Journals - MOST Wiedzy

TASK Quarterly

INFLUENCE OF ADDITION OF CARBON NANOTUBES ON RHEOLOGICAL PROPERTIES OF SELECTED LIQUID LUBRICANTS - A COMPUTER SIMULATION STUDY

Abstract

This work is motivated by the improvement of anti-friction properties of lubricants by addition of CNTs proved experimentally in literature. In particular, a methodology is developed to compute the shear viscosity of liquid lubricants (Propylene Glycol) based on Molecular Dynamics simulation. Non-Equilibrium molecular dynamics (NEMD) approach is used with a reactive force field ReaxFF implemented in LAMMPS. The simulations are performed using the canonical (NVT) ensemble with the so-called SLLOD algorithm. Couette flow is imposed on the system by using Lees-Edwards periodic boundary conditions. Suitable parameters such as simulation time and imposed shear velocity are obtained. Using these parameters, the influence of addition of 27 wt% CNTs to Propylene Glycol on its viscosity is analyzed. Results show that 3.2 million time-steps with a 0.1 fs time-step size is not sufficient for the system to reach equilibrium state for such calculations. With the available computational resources, a shear velocity of 5 × 10−5Å/fs was observed to give viscosity value with approximately 43% error as compared to the experimental value. Moreover, the lubricant exhibited a shear thinning behaviour with increasing shear rates. CNTs enhanced the lubricant’s viscosity by 100-190% depending upon the averaging method used for calculation.

Keywords:

Nanotechnology, tribology, lubricants, rheology, propylene glycol, carbon nanotubes, non-equilibrium molecular dynamics

Details

Issue
Vol. 24 No. 4 (2020)
Section
Research article
Published
2020-12-29
DOI:
https://doi.org/10.34808/tq2020/24.4/c
Licencja:
Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.

Authors

  • ANJALI CHOPRA

    Gdansk University of Technology, Faculty of Applied Physics and Mathematics
  • SZYMON WINCZEWSKI

    Gdansk University of Technology, Faculty of Applied Physics and Mathematics

Download paper